Band Heaters

Band Heaters:Related Image
・Materials

[ M ] Material: Cover of the Heater : 430 Stainless Steel
Mica for Insulation : Synthetic Mica
Nickel-chrome Wire: Nickel Chrome Ribbon Wire
Lead Wire: Nickel Copper Coated Wire
Lead Wire Heat Resistance Temperature: 180°C

[ A ] Accessories: Insulation Glass
(MBHS: 2 pcs. / MBHD: 4 pcs.)

Specifications

Part Number
MBHS40
Part Number(d)V (Voltage)W
(Electric Power)
LElectrical Power Density
(W/cm2)
TypeNo.
MBHS4040200150304.0
5050200
MBHD100100250502.0
120120300
150150400

Part Number 

  • Incomplete part number.
    Please use left hand selections to complete a part number.
Loading...
Part Number
MBHD100
MBHD120
MBHD150
MBHS40
MBHS50
Part NumberVolume DiscountDays to Ship RoHSRated Output
(W)
Rated Output
(W)
Available

Same Day

Stock

Compliant150~250250
Available

4 Days or more

Compliant300~560300
Available

4 Days or more

Compliant300~560400
Available

4 Days or more

Compliant150~250150
Available

4 Days or more

Compliant150~250200

Loading...

  1. 1

Lead Time

Band Heaters:Related Image

More Information

■Feature
· The band heater is a thin cylinder heater, coated with stainless steel plate, whose nickel-chrome wire is insulated with a heat-resistant mica board.
· One-piece type and two-piece type are available for different diameters of the heated object.
One-piece Type: Suitable for the cylinder of small diameter. 1 unit (2 pcs.) of terminals are included. Two-piece Type: Suitable for the cylinders of relatively large diameter. 2 units (4 pcs.) of terminals are included.
■Usage
· Band heater can be used for cylinder shaped heated objects (workpiece).
· Principal usages are:
Heating of hot nozzles, pipes and cylinder shaped metal plates

■Precautions for Use
[ ! ]Never operate the heater when it is empty. Doing so may result in damage to the unit.
[ ! ]Apply electric power under the condition in which an object such as metal to be heated is attached to the heater.
[ ! ]Attach the object so that the heater comes into close contact with the surface to be heated.
A gap will cause premature breakage of wire.
[ ! ]After installation, energize it for several minutes, and tighten them once more after heated.
In doing so, be sure to avoid burn injury.
[ ! ]The heater is not waterproof. Never expose the heater to water or any other liquids.
[ ! ]Do not use over the rated voltage (V).
[ ! ]Use the temperature controller for safety.
[ ! ]Do not mount One-piece Type flat.
(Put the heated object through the heater.)

Example

Band Heaters:Related Image
 

Basic Information

Voltage(V) 200 Voltage(V) 200

Additional Products in this Category

Complementary Products

Customers Who Viewed This Item Also Viewed

Tech Support

Automation Components Group
Tel:800-681-7475 (ext. 360) / FAX:800-681-7402
Mon. - Fri. 8:30 a.m. - 8 p.m. ET